Athena C10 line Instrukcja Obsługi Pobierz pdf (Strona 22)

none

bar

PSI

8. To select the protocol type, the value between 0 and 1 must be

assigned as per the below table:

Protocol type Serial value

Modbus 0

JbuS 1

9. To select the serial comm.s baud rate, the value between 0 and 3 must

be assigned as per the below table:

Baud Rate Serial value

1200 0

2400 1

4800 2

9600 3

10. To select the retransmission signal type, the value between 0 and 1

must be assigned as per the below table:

Retransm. signal type Serial value

0 .. 20 mA 0

4 .. 20 mA 1

7.5 Termination and Polarisation

The Platinum ® C10 and M10 instruments do not have any line

termination or polarisation system. If necessary a termination resistance

(120Ω ¼ W) must be connected to the terminals of the last instrument of

the line. In any case the polarisation is not possible.

8. M300 Controller

8.1 Bit zone

Address

Modbus JbuS Variable Type

0 1 Timer function status (0 = OFF, 1 = Run)

R/W

1 2 - -

2 3 - -

3 4 Main output condition (0 = OFF, 1 = ON) R

4 5 Alarm condition AL2 (0 = OFF, 1 = ON) R

5 6 Alarm condition AL3 (0 = OFF, 1 = ON) R

6 7 Out of range (0 = Normal operation, 1 = Safety) R

7 8 Auto-Tune (0 = OFF, 1 = Run) R

8 9 - -

9 10 Out of range (0 = Normal operation, 1 = Safety) R

10 11 Keypad lock (0 = locked, 1 = unlocked) R/W

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 106 107

Brak uwag

Athena C10 line Instrukcja Obsługi Strona 22